Skip to content
Need Expert Advice? Give us a Call: (855) 236-5000
Best Prices, Fast Shipping & Expert Advice!
Muzzle-Loaders Bullet Starter w/ 6 Adapter Tips - MZ1500

Muzzle-Loaders Bullet Starter w/ 6 Adapter Tips - MZ1500

A must for shooters seeking maximum accuracy
Adapts to any hollow or polymer point bullet

Save $3.01 Save $3.01
Original price $20.00
Original price $20.00 - Original price $20.00
Original price $20.00
Current price $16.99
$16.99 - $16.99
Current price $16.99
SKU MZ1500


The™ Bullet Starter helps you load any bullet quickly and easily. Many tight-fitting black powder projectiles, especially sabots, must be virtually hammered down the bore in order to get them to seat correctly. This abuse causes damage to the bullet tip. Any deformation of the bullet tip during the loading process will destroy the aerodynamic integrity of the bullet. Commonly, most of the damage done to the bullet tip is done after the projectile is in the barrel. Thus, many shooters never figure out why their hollow or polymer points are producing inconsistent groups. 

The™ Bullet Starter solves these problems. The  Muzzle-Loaders™ starter comes with loading tips that engage the bullet at either the base of the hollow point cavity or around the polymer point. Any projectile can be loaded without damaging the bullet, ensuring that the perfect bullet you start down the barrel stays that way until it hits the target.

The™ Bullet Starter comes with two sets of 2 loading tips to fit almost all hollow point bullet designs and one set of 2 tips for polymer point bullets. One tip goes on the short rod of the starter, one on the long rod, and one on the ramrod.


1. Determine which tips fit the bullet you are using. The hollow point tips should reach the base of the hollow cavity, use the concave tips for polymer tipped bullets.

2. Thread the tip into both the long and short starter on the bullet starter.

3. Place the projectile so that the tip engages the projectile.

4. Place the bullet starter with the adapter tip over the projectile so that the tip engages the projectile.

5. Press the handle to start the bullet into the barrel.

6. Use the long starter to push the projectile further down the barrel.

7. Use the ramrod to fully seat the projectile against the powder charge.

***Ensure the muzzleloader is unloaded before loading. Never lean over or stand in front of the muzzle at any time. Always ensure the projectile is firmly seated against powder charge when loading.


Bullet Adapter Tips


Customer Reviews

Based on 7 reviews Write a review