Skip to content
Need Expert Advice? Give us a Call: (855) 236-5000
Best Prices, Fast Shipping & Expert Advice!
Muzzle-Loaders Bullet Starter w/ 6 Adapter Tips - MZ1500

Muzzle-Loaders Bullet Starter w/ 6 Adapter Tips - MZ1500

A must for shooters seeking maximum accuracy
Adapts to any hollow or polymer point bullet

Save $3.01 Save $3.01
Original price $20.00
Original price $20.00 - Original price $20.00
Original price $20.00
Current price $16.99
$16.99 - $16.99
Current price $16.99
SKU MZ1500


The™ Bullet Starter helps you load any bullet quickly and easily. Many tight-fitting black powder projectiles, especially sabots, must be virtually hammered down the bore in order to get them to seat correctly. This abuse causes damage to the bullet tip. Any deformation of the bullet tip during the loading process will destroy the aerodynamic integrity of the bullet. Commonly, most of the damage done to the bullet tip is done after the projectile is in the barrel. Thus, many shooters never figure out why their hollow or polymer points are producing inconsistent groups. 

The™ Bullet Starter solves these problems. The  Muzzle-Loaders™ starter comes with loading tips that engage the bullet at either the base of the hollow point cavity or around the polymer point. Any projectile can be loaded without damaging the bullet, ensuring that the perfect bullet you start down the barrel stays that way until it hits the target.

The™ Bullet Starter comes with two sets of 2 loading tips to fit almost all hollow point bullet designs and one set of 2 tips for polymer point bullets. One tip goes on the short rod of the starter, one on the long rod, and one on the ramrod.


1. Determine which tips fit the bullet you are using. The hollow point tips should reach the base of the hollow cavity, use the concave tips for polymer tipped bullets.

2. Thread the tip into both the long and short starter on the bullet starter.

3. Place the projectile so that the tip engages the projectile.

4. Place the bullet starter with the adapter tip over the projectile so that the tip engages the projectile.

5. Press the handle to start the bullet into the barrel.

6. Use the long starter to push the projectile further down the barrel.

7. Use the ramrod to fully seat the projectile against the powder charge.

***Ensure the muzzleloader is unloaded before loading. Never lean over or stand in front of the muzzle at any time. Always ensure the projectile is firmly seated against powder charge when loading.


Bullet Adapter Tips


Customer Reviews

Based on 7 reviews
A must for full bore bullets

The best bullet starter hands down.

Great bullet starter

Bought this on their online store. Love it because it comes with all the adapters needed for your bullet. this is the best bullet starter I have found, I have two now highly recommend. No more plastic ones for me.

Great piece of kit

After having thoroughly destroyed the plastic ball starter that came in the starting kit with my rifle, I quickly opted for this upgrade. Gets the job done. Feels solid and I appreciate all the loading jags. My only complaint is common to all of this type starter, I think. When you have a particularly hard to start bullet and are really going after it, you can end up with a rather unexpected and violent first start down to the wooden ball - which can cut up the skin around your fingers pretty good if you're not careful. Undoubtedly there's better technique (I've just started with ML's), but it's happened enough that I'm going to test out the CVA Knuckle-saver starter!

Larry Walkley
Great Upgrade

Great bullet starter. Had been using a traditions 5-1 Speed Loader/Starter and some bullets were very difficult to get started for my dad. Bought him this when I purchased a new Muzzleloader and its now very simple for him to start the bullet. Would recommend for a wide variety of bullets.

MZ Bullet Starter

Heavy duty starter.